
Materials:
- Lollipop Mold 30 sheets toilet paper
- White glue
- Teaspoon
- 1/4 cup water
- Heart-shaped lollipop mold*
- Scissors
- 1 card
- Double-stick tape
- Vellum paper with quotes and designs
- Thin white ribbon
Craft Instructions:
1. Place toilet paper sheets in a stack on a disposable plastic plate.
2. Add 1 teaspoon of glue to ¼ cup of water and mix well.3. Pour glue-water mixture over toilet paper until saturated (photo Step 3).
4. Place wet toilet paper stack over lollipop mold and press down, so paper gets into the impression of the mold (photo Step 4). Allow paper to dry completely. You can speed up the drying process by using a blow dryer like I did in the video.

5. Unmold the paper heart. Trim around the heart to get rid of the excess paper (photo Step 5).

6. Use double-stick tape to put a vellum paper rectangle on the front of the card as an overlay. Then, add a quote to the bottom half of the card.Look in the scrapbook section of the craft store for quotes on vellum paper or use clear quote stickers.
7. Glue the paper heart on to the top half of the card (photo Step 7). Use glue to attach a white ribbon as an accent on the heart.

*Label the lollipop mold as "crafts" as it should no longer be used for food after you have used it for crafting.

For reference, see the how-to craft videos for these cards and make her Mother's Day with a handmade memento!
- Materials:
- 2 sheets decorative paper
- Scissors or paper cutter
- 1 card
- Double-stick tape
- 1 metal frame & vellum tag
- 1 tack
- 2 colorful mini brads
- Zots 3-D glue dots
- 2 small round jewels
- Crystal letter stickers
1. Cut 1 sheet of decorative paper into a rectangle that is½-inch smaller in length and width to the card’s measurement. Usedouble-stick tape to put the rectangle on the front of the card.
2. Cut the other sheet of decorative paper into arectangle that is 1-inch smaller in length and width to the card’smeasurement. Use double-stick tape to put the rectangle on top of thefirst one on the front of the card (photo Step 2).
Step 2
3. Place the metal frame vellum paper tag on the front of thecard. Use a tack to poke 2 holes through the vellum, paper layers, andcard at the points where you will insert the mini brads.
4. Insert the mini brads and bend back the prongs to secure.
5. Pull off a small piece of a glue dot and use it to attach a round jewel on the brad (photo Step 5).
Step 5
6. Spell “Mom” on the tag using crystal letter stickers.
Visit our Mother’s Day page for more ideas.
















